Your garage door is likely the largest moving object in your home. A simple twice-a-year checklist keeps it running smoothly and catches problems early.
Look and Listen
Run the door up and down and watch for jerky motion, scraping, or grinding. Look for frayed cables, bent tracks, or loose hardware.
Tighten Hardware
Vibration loosens bolts and brackets over time. Snug up roller brackets and track bolts with a socket wrench.
Lubricate Moving Parts
Use a garage door lubricant or white lithium grease on:
- Rollers (unless they’re nylon with sealed bearings)
- Hinges
- Springs
- Opener chain or screw
Don’t grease the tracks themselves — wipe them clean instead.
Test the Safety Features
- Auto-reverse: Place a board or roll of paper towels where the door closes. It should reverse on contact.
- Photo-eye sensors: Wave something through the beam as the door closes. It should reverse.
If either test fails, adjust or repair before using the door.
Check the Balance
Disconnect the opener (with the door closed) and lift the door by hand about halfway. A balanced door stays put. If it falls or shoots up, the springs need adjustment.
Leave Springs and Cables to Professionals
Torsion springs and lift cables are under extreme tension and can cause serious injury. Call a garage door technician for these.
Weatherstripping and Seals
Inspect the bottom seal for cracks and gaps. A worn seal lets in water, pests, and cold air. Replacement seals are inexpensive and fit into a track on most doors.
Keep the Track Clear
Remove debris, leaves, and dirt from the tracks. Make sure nothing is blocking the photo-eye sensors near the floor.
Opener Maintenance
Replace the remote battery when range drops, and check the opener’s manual for maintenance steps. Consider a battery backup if you lose power often.
Quick Summary
- Look, listen, and tighten hardware twice a year
- Lubricate rollers, hinges, and springs
- Test auto-reverse and sensors
- Never adjust springs or cables yourself